| View previous topic :: View next topic |
| Author |
Message |
enihcam
Joined: 07 Jan 2015
Posts: 8
|
 Posted: Wed Jan 07, 2015 11:40 pm Post subject: "No IGD UPnP Device found on the network" (rp_filt |
 |
|
Hi. I'm new to miniupnpd and iptables.
I tried to test the upnp gateway with upnpc client, but I always got
| Code: |
No IGD UPnP Device found on the network !
|
| Code: |
tcpdump: verbose output suppressed, use -v or -vv for full protocol decode
listening on wlp1s0, link-type EN10MB (Ethernet), capture size 262144 bytes
11:55:27.457700 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 396
11:55:27.457785 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 468
11:55:27.457828 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 405
11:55:27.457866 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 464
11:55:27.457904 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 405
11:55:27.457943 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 444
11:55:27.457980 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 405
11:55:27.458019 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 476
11:55:27.458057 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 458
11:55:27.458095 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 460
11:55:27.708836 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 460
11:55:27.708903 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 458
11:55:27.708929 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 476
11:55:27.708956 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 405
11:55:27.708980 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 444
11:55:27.709005 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 405
11:55:27.709028 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 464
11:55:27.709054 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 405
11:55:27.709080 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 468
11:55:27.709106 IP archnet.51193 > 239.255.255.250.ssdp: UDP, length 396
^C
20 packets captured
20 packets received by filter
0 packets dropped by kernel
|
Any ideas?
Thanks.
| Code: |
net.ipv4.conf.all.rp_filter = 0
net.ipv4.conf.default.rp_filter = 0
net.ipv4.conf.enp2s0.rp_filter = 0
net.ipv4.conf.ppp0.rp_filter = 0
net.ipv4.conf.wlp1s0.rp_filter = 0
|
| Code: |
IPv6/IPv4 Group Memberships
Interface RefCnt Group
--------------- ------ ---------------------
lo 1 224.0.0.1
enp2s0 1 224.0.0.1
wlp1s0 1 239.255.255.250
wlp1s0 1 224.0.0.252
wlp1s0 1 224.0.0.1
ppp0 1 224.0.0.1
|
| Code: |
Kernel Interface table
Iface MTU RX-OK RX-ERR RX-DRP RX-OVR TX-OK TX-ERR TX-DRP TX-OVR Flg
enp2s0 1500 2283 0 508 0 1717 0 0 0 BMRU
lo 65536 261 0 0 0 261 0 0 0 LRU
ppp0 1480 1580 0 0 0 1584 0 0 0 MOPRU
wlp1s0 1480 0 0 0 0 1693 0 0 0 BMRU
|
| Code: |
1: lo
inet 224.0.0.1
2: enp2s0
link 01:00:5e:00:00:01
inet 224.0.0.1
3: wlp1s0
link 01:00:5e:00:00:01 users 2
link 01:00:5e:00:00:fc users 2
link 01:00:5e:7f:ff:fa users 2
inet 239.255.255.250
inet 224.0.0.252
inet 224.0.0.1
4: ppp0
inet 224.0.0.1
|
| Code: |
Chain INPUT (policy DROP 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
1242 128K ACCEPT all -- * * 0.0.0.0/0 0.0.0.0/0 ctstate RELATED,ESTABLISHED
36 2222 ACCEPT all -- lo * 0.0.0.0/0 0.0.0.0/0
4 274 DROP all -- * * 0.0.0.0/0 0.0.0.0/0 ctstate INVALID
166 8016 TCP tcp -- * * 0.0.0.0/0 0.0.0.0/0 tcp flags:0x17/0x02 ctstate NEW
18 1005 UDP udp -- * * 0.0.0.0/0 0.0.0.0/0 ctstate NEW
166 8053 REJECT tcp -- * * 0.0.0.0/0 0.0.0.0/0 reject-with tcp-reset
18 1005 REJECT udp -- * * 0.0.0.0/0 0.0.0.0/0 reject-with icmp-port-unreachable
1 28 REJECT all -- * * 0.0.0.0/0 0.0.0.0/0 reject-with icmp-proto-unreachable
Chain FORWARD (policy DROP 0 packets, 0 bytes)
pkts bytes target prot opt in out source destination
0 0 ACCEPT all -- * * 0.0.0.0/0 0.0.0.0/0 ctstate RELATED,ESTABLISHED
0 0 ACCEPT all -- wlp1s0 * 0.0.0.0/0 0.0.0.0/0
0 0 TCPMSS tcp -- * * 0.0.0.0/0 0.0.0.0/0 tcp flags:0x06/0x02 TCPMSS clamp to PMTU
0 0 REJECT all -- * * 0.0.0.0/0 0.0.0.0/0 reject-with icmp-host-unreachable
0 0 MINIUPNPD all -- ppp0 !ppp0 0.0.0.0/0 0.0.0.0/0
Chain OUTPUT (policy ACCEPT 2890 packets, 857K bytes)
pkts bytes target prot opt in out source destination
Chain MINIUPNPD (1 references)
pkts bytes target prot opt in out source destination
|
|
|
| Back to top |
|
 |
miniupnp
Site Admin
Joined: 14 Apr 2007
Posts: 1593
|
| Posted: Tue Jan 20, 2015 1:22 pm Post subject: |
|
|
your setup has several network interfaces.
Make sure the right one is selected for multicast...
What is the IP (LAN) of your UPNP router ?
_________________
Main miniUPnP author.
https://miniupnp.tuxfamily.org/ |
|
| Back to top |
|
|
enihcam
Joined: 07 Jan 2015
Posts: 8
|
| Posted: Tue Sep 15, 2015 11:40 am Post subject: |
|
|
| miniupnp wrote: | your setup has several network interfaces.
Make sure the right one is selected for multicast...
What is the IP (LAN) of your UPNP router ? |
192.168.1.1 |
|
| Back to top |
|
|
miniupnp
Site Admin
Joined: 14 Apr 2007
Posts: 1593
|
| Posted: Tue Sep 15, 2015 11:56 am Post subject: |
|
|
what is the output of | Code: | | # miniupnpd -i ppp0 -a 192.168.1.1 -d |
?
I'm not an iptable expert, but you should make sure UDP multicast packets are allowed on your LAN interfaces.
_________________
Main miniUPnP author.
https://miniupnp.tuxfamily.org/ |
|
| Back to top |
|
|
|
|
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum
|
Powered by phpBB © 2001, 2005 phpBB Group
© 2007 Thomas Bernard, author of MiniUPNP.
|
FAQ
Search
Memberlist
Usergroups
Register
Profile
Log in to check your private messages
Log in
